Isolation of noise and vibration in pools.

NOISE AND VIBRATION ISOLATION OF SWIMMING POOLS

1/23/2015

INTRODUCTION

  • Having a rooftop pool has its advantages

  • Extra value for the sale

  • No loss of buildable land

  • Transmission of noise and vibration to the rest of the building

If the pool is not properly isolated, there can be significant transmission of airborne noise and structural vibration to adjacent flats, causing discomfort for residents.

The best approach is to isolate the pool during construction to avoid bigger problems in the future, as retrofitting is much more difficult. However, some existing pools have no isolation, so it has to be added afterwards.

Below we explain how to solve noise problems in pools that need to be refurbished.

That is why AMC MECANOCAUCHO® considers it necessary to offer solutions with vibration specialists for this type of application. A good solution is to use Sylomer to elastically decouple the pool structure from the rest of the building. Pools have different parts that need treatment; solutions for each of them are shown below.

installation

AREAS TO TREAT

There are two main areas of a pool that need treatment:

  • The pool basin (the structure that holds the water)

  • The pool deck (the surface surrounding the basin)

installation

At AMC MECANOCAUCHO® we propose different solutions depending on the characteristics of the project to elastically isolate existing pools. The following sections show different options for both parts.

SOLUTIONS FOR THE BASIN

Option 1: REINFORCED CONCRETE BASIN WITH SYLOMER OVER THE EXISTING POOL

The slab adds inertia to the system, making it more stable and absorbing part of the vibrations.

The thicker the basin, the more inertia it adds to the system; that is, it is more stable and absorbs part of the vibrations.

For this application Sylomer is one of the best options, as it is a microcellular polyurethane with very good isolation properties. It would be placed as shown in yellow in the image below.

installation

Option 2: PREFABRICATED METAL BASIN WITH SYLOMER OVER THE EXISTING POOL

Sometimes a new concrete basin is not possible, so a prefabricated metal basin is used.

installation

These basins often have a metal frame made of bars, so Sylomer strips can be placed on those bars.

installation

SOLUTION FOR THE DECK

As well as correctly isolating the pool basin, at AMC MECANOCAUCHO® we believe the pool deck should also be elastically supported.

The AMC solution adapts to the different types of deck a pool can have.

Depending on how the floor is supported, one of the following three options is adopted:

  • CONTINUOUS SURFACE: using Sylomer mats or acoustic floor mats, as shown in the following images.

installationinstallation
installationinstallation
  • STRIPS: with the same materials mentioned above.

installation
  • POINT SUPPORTS: using Sylomer floor blocks, decoupling can be achieved with point supports instead of full surfaces.

installation
installation

SKIMMER

Both the pool basin and its components must be elastically decoupled.

This image shows an example of how the skimmers can be installed so that there are no acoustic bridges.

installation

CASE STUDY

To demonstrate the above, here are the results of a real project where a pool was installed with and without Sylomer. The improvement in isolation is confirmed by the following measured values:

Untreated pool

45 dB(A) + 9 dB(A) penalties -> 54 dB(A)

Pool after installing Sylomer

34 dB(A) + 3 dB(A) penalties -> 37 dB(A)

installation

Isolation with Sylomer

Since the dB scale used in acoustics is logarithmic, this 17 dB reduction means an attenuation of noise and vibration of around 85%.

Original report (PDF)